Do I remove jets and screws whilst using the ultrasonic cleaner?

Bill Pilkington

Last Update a year ago

Removing small brass jets can be sometimes difficult. The screwdriver slot in the jet breaks easily especially if it's been in situ for years. However, if you don't remove the jet, the ultrasonic process can loosen dirt which then gets stuck behind it and the alloy carburettor body. The more parts you can remove from the carb, the better and more thorough the clean will be. I would remove all jets, slides, float bowls etc.

Was this article helpful?

2 out of 2 liked this article

Still need help? Message Us